Installing an aluminum fence in Pinehurst, NC can be a daunting task. But with this simple step-by-step guide, you'll have your new fence up and running in no time. First, take the time to measure the area where your fence will go. This will ensure that you purchase enough materials for the job. Next, gather all of the necessary tools and supplies to install your aluminum fence. These include wire cutters, drill bits, lag bolts and screws, post hole diggers or augers, and concrete mix. Once everything is ready to go, it's time to begin installation. Start by digging your post holes about two feet deep and nine inches wide at each corner point of your fence line. Then place posts into each hole and fill with concrete mix until they are level with the ground surface. Assemble panels between posts using screws or lag bolts as needed for stability before attaching them to posts firmly with lag bolts or screws. Finally, check for any gaps between panels and if needed use additional fasteners such as nuts and washers to secure them together tightly. With these easy steps you'll have a beautiful aluminum fence surrounding your home in no time!